Yamaha MC1602 - Manual (Page 5)

0
AUX Controls (1,2 &3)
The MC-series mixing consoles have three independent AUX busses which are -fed by the
corresponding AUX controls on the input channels. Each AUX control determines the level of
the signal sent from that channel to the correspondingly numbered AUX mixing buss, which in
turn feeds the correspondingly numbered AUX SEND control and AUX SEND jack on the
console's rear panel. The AUX controls can be used to determine the amount of signal from the
corresponding input channel sent to external effect devices or power amps fed by the AUX
SEND jacks.
* AUX 1 is factory pre-wired for pre-EQ/pre-fader operation, so the AUX 1 signal is not
affected by the setting of the channel EQ controls or fader. An internal jumper allows the
AUX 1 control to be rewired for post-EQ/post-fader operation.
* AUX 2 and AUX 3 are factory pre-wired for post-EQ/post-fader operation, so the AUX 2
and AUX 3 signals are affected by the setting of the channel EQ controls and fader. Internal
jumpers allow the AUX 1 control to be rewired for pre-EQ/pre-fader operation.
* An internal PQST EQ jumper allows the AUX controls to be further re-configured for
post-EQ/pre-fader operation.
* REFER THE ABQVE-MENTIQNED REWIRING JQBS TQ QUALIFIED YAMAHA SER­
VICE PERSQNNEL!
@ PAN Pots
The PAN pot determines the position in the stereo sound field at which the sound from that
channel is heard. Rotated fully counterclockwise the channel signal will be delivered from the
left stereo output only, and will be heard at the far left of the sound field. If the PAN pot is
turned fully clockwise, the sound from that channel will appear at the far right of the stereo
sound field. If the PAN pot is set at its center position, the channel signal will be sent equally
to both the left and right channels, causing the sound to appear at the center of the sound field.
Intermediate PAN pot settings cause the sound to be heard at the corresponding position.
Ql CUE Switch
When the CUE switch is pressed, the pre-EQ/pre-fader signal from that channel is fed to the
PHQNES output via the CUE/PHONES level control. The channel cue signal will be added to
any other active cue signal. If you want to monitor only the signal from a single channel, make
sure all other CUE switches are turned OFF.
I