Panasonic QUICKDRAW MC-V7377 - Manual (Page 9)

-i'' ' >■" ,-.y - ■■ -= t“-.
t ¿:::f FLOOR SEllgSTOR
To use cleaner on bare floors, the
carpet/bare floor selector on top of the noz­
zle should be positioned all the way back
and down toward the bottom of the nozzle
until it locks into place. When the selector is
In this position №e agitator does not turn. This
is also the correct position to place the selector
in to use the attachments. Any time the attachments
are used the agitator should not be turning.
To use cleaner on carpeted areas, the carpet/bare floor
selector should be all the way forward and up to the carpet
position. This will allow the agitator to turn. When carpets are being cleaned the
selector should remain in this position.
Take care when selecting either position to make sure the selector is pushed fully and quickly
as possible to the desired position. Failure to do so can cause the belt to rub on the selector
shaft and may result In the belt becoming hot and creating a burning rubber smell.
To prevent injury when returning the selector to the carpet position, use caution as the selector
can move quiddy upward due to tension caused by the belt.
/
Bare Floor/
Carpet Selector
To clean bare floor
or use attachmenta
To clean carpef
Hose
Ring Knob
The hose ring Is a feature designed to prevent tipping of the vacuum
while performing certain tasks that involve the use of the attachments. To
use this anti-tip feature, place the
hose ring In the hose ring mount as
shown in the illustration. Rotate this
ring on tile hose so that the hose ring
knob will align with the slot in the
hose ring mount and slide the
ring down firmly until it stops.
For recommendations on when
to use the hose ring and the
exact location of the hose ring
mount see the ATTACHMENTS
section.
- 9 -