Compaq V6500 - Manual (Page 63)

4 . Open the computer as far as possible.
5 . Lift the rear edge of the keyboard (1) until it rests at an angle.
6 . Release the keyboard (2) by sliding it back to disengage the tabs on the front edge of the keyboard
from the top cover.
7 . Swing the keyboard (3) up and forward until it rests on the palm rest.
8 . Release the ZIF connector (1) to which the keyboard cable is attached, and disconnect the keyboard
cable (2) from the system board.
9 . Remove the keyboard.
Reverse this procedure to install the keyboard.
Component replacement procedures 55