Aviom AN-16/i v.2 - Manual (Page 43)

35 AN-16/ i v .2 i Nput M odule u ser G uide
Rear Panel Setup for Pro16e Systems
When creating a Pro16e personal mixing system it is important that the S
lOt
r
ANge
switch on each input
module be set correctly. This switch assigns the incoming audio signals for each AN-16/i v.2 in use to a
specific Slot Range within the Pro16e A-Net stream.
32-Channel Example
Using two AN-16/i v.2 Input Modules provides up to 32 mono or 16 stereo sources to A360 Personal
Mixers. The 32-channel Pro16e A-Net stream created by this setup appears at the A-N
et
O
ut
on the second
AN-16/i v.2. The first AN-16/i v.2 should be set to Slot Range 1-16; the second AN-16/i v.2 should be set
for 17-32. Connect a Cat-5e UTP cable from A-N
et
O
ut
on the first AN-16/i v.2 to A-N
et
I
N
on the second
AN-16/i v.2 Input Module.
Set the Slot Ranges to 1-16 and 17-32 on the input modules.
Connect a Cat-5e cable from its A-N
et
O
ut
to the A-N
et
I
N
of an A-Net distributor and then connect Cat-5
cables from the distributor to the A360 Personal Mixers.
Connect audio sources to the AN-16/i v.2 audio inputs and then set the stereo link switches as needed per
channel pair.
P N
ote
: When adding the AN-16/i v.2 to an existing Pro16 system to expand the system’s channel
count for use with A360 Personal Mixers, the original input device in the system defaults
to Slot Range 1-16. Connect the original input device’s A-N
et
O
ut
to the A-N
et
I
N
on the
AN-16/i v.2 and set the AN-16/i v.2 to Slot Range 17-32.