Casio XJ XJ-360 - Manual (Page 13)

E-13
Getting Ready
En
gl
is
h
Note that the condition of the environment
where you use the projector greatly affects its
performance. Make sure that the following are
the conditions of projector setup whenever you
use it.
z Use a conveniently located power outlet that
you can reach easily when you need to
unplug the projector.
z Do not place any objects within the area
indicated by the dashed line in the
illustration below. Be especially careful that
you never block intake and exhaust vents.
z Do not locate any objects near the projector
while it is in use. Keep all items at least
30cm (11.8 inches) away from the exhaust
vents.
z The vents become quite hot while the
projector is in use. Never touch the vents
with your hands. Also, the areas near the
exhaust vents also become quite hot. Never
locate objects made of plastic or other heat-
sensitive materials near or under the
projector. Doing so creates the risk of
deformation and discoloration of the object.
z Avoid placing the projector on a surface that
is unstable or prone to vibration. Never
place the projector on top of a carpet,
blanket, towel, or other soft material.
z Do not locate the projector where it will be
exposed to direct sunlight.
z Avoid locations where there are large
amounts of dust and moisture.
z Keep the projector away from speakers,
TVs, radios, and other devices that generate
magnetism, as well as from heaters.
A fan inside the projector draws air through
an intake vent on the bottom of the projector
to cool the lamp. Be sure to observe the
following precautions whenever using the
projector.
z Over time, use of the projector can cause
dust and dirt to build up in and around the
fan’s intake vent, which can lead to
malfunction of the projector. Be sure to
check the intake vent for dust build up each
time before you use the projector. If you
see dirt or dust in or around the intake
vent, remove it by wiping with a cloth, etc.
z When positioning the projector, make sure
you do so in such a way that the intake
vent on the bottom does not become
blocked. A blocked intake vent can shorten
the life of the lamp.
Setup Precautions
Exhaust vents
Allow sufficient
clearance and do not
block intake vents.
Intake vents
30 cm
(11.8 inches)
Allow sufficient
clearance and
do not block
vents.
Fan intake vent
<How to Position the Projector Correctly>