California Faucets 1/2" Pressure Balance Valve Tirim User Manual
Page 3
TO-PBL-XX_ii_110112.doc
Pg
3
2
2
½”
1
/
32
”
3
INSTALL TRIM
Important: Prior to performing the next steps, the
finished wall surface MUST be completed
• Attach BUSHING (10) onto CARTRIDGE NUT
(9)
• Place SHOWERPLATE (11) onto BUSHING (10)
• Tighten ESCUTCHEON (12) or (12a) onto
BUSHING (10) until SHOWERPLATE (11) is
secure to finished wall surface. An additional
BONNET (12b) may be supplied based on product
style, this BONNET (12b) shall be attached to
ESCUTCHEON (12a) prior to affixing HANDLE
(13)
• Trim STEM (15) to allow ½” of STEM (15) to
protruded out from ESCUTCHEON (12)
• Place HANDLE (13) onto STEM (15)
• Allow for
1
/
32
” (thickness of credit card) of gap
between ESCUTCHEON (12) and HANDLE (13)
• Tighten SETSCREW (14) to secure HANDLE (13)
onto STEM (15)
NOTE: Trim extension kits available for extra thick
finished wall and/or valve positioned too deep into wall
MAINTENANCE
• For detailed maintenance of the valve components:
See PB-R ½” Pressure Balance Valve Rough
Installation Instructions
IMPORTANT: After performing any maintenance procedures, it is
necessary to verify TEMPERATURE SETTINGS
• See .
1
. TEMPERATURE SETTING
• See .
2
. INSTALL TRIM