FRITSCH ANALYSETTE 18 - Manual (Page 18)

1. Screw the ring bolts provided in the corresponding bore holes.
2. Then lift the device out of the transport crate with the crane.
3. Place the device indoors, ideally, on a concrete floor. It does not
have to be fastened to the surface.
NOTICE!
Do not use any rubber pads!
NOTICE!
Never operate the device while it is standing on the
transport pallet!
4.4 Mounting the guide rods
The sieve shaker is delivered fully assembled, apart from the
guide rods.
1. Remove the ring bolts.
2. Screw the guide rods (2) into the thread of the vibrating plate (1)
and tighten with the spanner.
Installation
- 18 -