Kofax Transformation Modules 3.5 - Manual (Page 20)

12 Kofax Transformation Modules Installation Guide
4. Follow the instructions in the setup wizard until the Feature Select window
is shown.
5. Clear the Project Builder and Statistics option and continue the installa-
tion, otherwise an error message appears and the installation is cancelled.
Note that silent install can only be used for Kofax Transformation Mod-
ules - Server and the Kofax Transformation Modules - Validation.
Important If you have chosen to install Kofax Transformation Modules -
Server, the Kofax Transformation - Service Configuration dialog box will
display. Note that those settings are not used when you run the silent in-
stallation file for Kofax Transformation Modules - Server on a target sys-
tem. An additional installation step to run the Kofax Transformation - Ser-
vice Configuration on the target system is obligatory to complete the Serv-
er installation.
Use the following instructions to perform silent install on the target system.
➤ To run a silent installation file for Kofax Transformation Modules
1. If necessary, copy the silent installation file to the target system. This is
necessary only when the recording file is not located on a network drive
that can be accessed by the target system.
2. On the target system, select Start | Run and enter cmd to open a command
window.
3. Within the command window, change to the folder that contains the Ko-
fax Transformation Modules setup file. If the setup is located on a network
drive, remember to map the network drive first.
4. Run the setup from the command line by entering the following command
setup /s /f1"FullNameResponseFile.iss" [/f2"FullNameLogFile"] [/
Verbose"FullNameDetailedLogFile"]
Parameters
/s
Runs the silent installation for a recorded file.