Whirlpool 9200 SERIES - Manual (Page 5)

Delaying a wash
2 HOURS
The DELAY pad allows you to delay the start of a
cycle for 2 hours after loading the dishwasher. For
example, use the DELAY to run the dishwasher
during off-peak hours of electrical use.
1. Press the DELAY pad once to display the last
cycle and options selection.
2. Select a new cycle and option (s), if desired.
3. Press the DELAY pad again to select a 2-hour
delay. The 2 HOURS signal light will come on.
NOTE: Immediately pressing the DELAY pad
again will cancel the selection. If no delay is
selected, the 2 HOURS signal light will be off.
4. After 2 hours, the signal light will turn off and the
dishwasher will start.
NOTE:
• You may press the START pad at any time
during the delay if you want the dishwasher to
start immediately.
• You may press the CANCEL/DRAIN pad to
cancel the delay and clear the delay signal light.
• You may add items to the load at any time during
the delay. Close the door firmly to latch it.
The CANCEL/DRAIN pad
The CANCEL/DRAIN pad allows you to cancel
a cycle, to clear the signal lights or to make a new
selection. If the dishwasher is washing, it will go
into a 2-minufe drain automatically before shutting
off. Pressing CANCEL/DRAIN again stops the
drain. If the dishwasher had not been started or is
not washing, it will clear the display. Pressing
CANCEL/DRAIN again will start a 2-minute drain,
if needed.
Using cycle pause
A cycle can be stopped at any time for up
to 10 minutes.
1. Press the DELAY pad. Any signal lights that are
on will flash slowly until the cycle restarts after
10 minutes.
2. The cycle can be started sooner by pressing the
START pad.