Operating ybur washer, Before starting your washer, Starting or stopping your washer – Whirlpool LSS7233AN0 User Manual
Page 5: Selecting a load size, Operating your, Washer
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
O P E R A T I N G Y O U R W A S H E R
Operating Ybur Washer
In This Section
Page
Page
Before starting your washer................. ........... 5
Using the SUDS-MISER* system....... ............. 8
Starting or stopping your washer......... ........... 5
Using rinse and spin.......................... ............. 9
Selecting a load size...............................
Using drain and spin.......................... ............. 9
Selecting wash-rinse temperatures .... ........... 6
What happens in each cycle............. ........... 10
Selecting a cycle and time..................... ........... 6
Operating your washer properly assures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before starting your washer
Add measured detergent. Then place a sorted
load in the washer before starting. See page 12
for additional “Before you wash” information.
NOTE: If your washer has a Consumer Buy
Guide, remove it and place it in your Use and
Care Guide.
Starting or stopping your washer
starting your washer:
1. Select a load size and water temperature.
2. Push in the Cycle Control Knob and turn it
clockwise. Stop when the indicator on the
knob’s outer ring points to the number in the
wash cycle you want. The numbers are
minutes of wash time.
3. Pull out the Cycle Control Knob.
Refer to pages 6-9 for additional information to
help you make selections.
Stopping and restarting your washer:
• To stop the washer at any time, push in the
Cycle Control Knob.
• To restart the washer, close the lid (if neces
sary) and pull out the Cycle Control Knob.
Selecting a load size
Position the Load Size Selector at the setting
that corresponds to the size load you want to
wash.
Select a load size based upon the size of the
load and the fabric you are washing. See
page 12 for additional loading information.
To change the load size setting after the
washer has started to fill, move the Selector to
the desired new setting.
Settings may vary with model