Whirlpool 8700 Series - Manual (Page 5)

Changing a cycle setting
You can change a setting anytime during any
cycle.
1. Lift up on the door latch to unlatch the door and
stop the cycle. Do not open the door until the
spray arms stop spinning.
2. Turn the Cycle Control Knob clockwise to the
cycle you want.
3. Be sure the detergent dispensers are filled
properly for the new cycle. When changing the
dial from LIGHT WASH to POTS & PANS,
HEAVY WASH or NORMAL WASH setting,
detergent is released. Reload covered section
of dispenser before starting Pots & Pans,
Heavy Wash or Normal Wash Cycles.
4. Close and latch the door. The dishwasher will
automatically start the new cycle.
a a
LO-ENERGY HI-TEMP AIR RESET
OPTION RINSE DRY OPTIONS
□□□□
Changing an option
If you want to change a selected option, push the
RESET OPTIONS Button. Re-select an option,
if desired'
UGHT WASH RINSE & HOLD
. USE AIR DRY
RIN!
HEAVY WASH B1 1 >
POTS & PANS "I 1 y
DELAY
WATER
HEATING
DELAY
WATER
HEATING
Using delay wash
You can set the dishwasher to start a cycle
from 1 to 4 hours later.
1. Push desired Cycle Selector Button.
2. Push desired Option Selector Button(s).
3. Turn Cycle Control Knob clockwise to the
number of hours (from 1 to 4 hours) you want
the dishwasher to delay before the selected
cycle starts.
4. Close and latch the door. The DELAY/WATER
HEATING Signal Light will come on until the
selected cycle starts.
NOTE:
• Yoiican add items while time is counting down.
Close and latch the door. The timer will not
advance if the door is unlatched.
• Rinse & Hold and Light Wash Cycles cannot be
delayed.
• The DELAY/WATER HEATING Signal Light will
also come on while the water is heating during
the Pots & Pans Cycle and Hi-Temp Rinse Option.
The clean signal light
The CLEAN Signal Light will come on when a
washing cycle is complete. To turn it off, turn the
Cycle Control Knob clockwise
slightly until the
light goes off.