Tfib set done, 5 sec, Tab clear – Brother CM-2000 User Manual
Page 63: Auto tab set, All tab clear
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting the Line Format
Ifyour number has an integer part before the decimal point, type this in. Each character you
type will appear on the display, and the carrier will move one space to the left.
If your number has a decimal point, type this. The integer part of the number and the
decimal point will be printed. You can then type the fractional part of the number, which
will be printed after the decimal point in the normal way.
If the number is an integer, press [TAB] to print the number and move to the next tab
position, or [RETURN] to print the number and end the line.
'’’
clh
Tab Clear
To clear a nonrial or decimal Lab:
1. Move the carrier to the position of that tab using [TAB].
2.
Hold down [CODE] and press the TAB CLEAR key - [T CLR].
TSET
CODE
2
+
\
--------- /
Auto tab set
^ 0.5 SEC
If [CODE] + [T SET] is pressed for more than half a second, tabs will be set every 10
columns from the current left margin position and the following message will appear
TfiB SET DONE
Note!
All tab set does not work with decimal tabs.
All Tab Clear
^ 0.5 SEC
If [CODE] + [T CLR] is pressed for more than half a second, all tabs will be cleared, and
the following message will appear
Jl”si !
"T!-:!“!!“ ¡"'I CTCiDHPi