Brother EM-430 - Manual (Page 46)

Advanced Typing
from memory, the typewriter does not make the mistakes you made. It prints the text
correctly the first time.
It is important to note that each line of text is stored if the [RETURN], [END] or [PINS]
key is pressed, when the [INDEX] or [R INDEX] key is pressed twice in a row or when
the [CODE] + [IND CLR] keys are pressed in the paragraph indent mode. The three
PITCH LEDs will blink to indicate the entry of data into the memory.
After a line oftext is stored, any (manual) corrections you subsequently make to it will not
be stored in memory, so try to make sure each line is correct before it is stored.
Notes:
The text memory stores no line format information except the pitch of the typed text.
Margins, line spacing and print impact must be set before you print the text from
memory.
When you use the [TAB] key in store mode, the carrier movement from the end of
the previous word to the tab position is stored as spaces in memory. Therefore, the
text will print from memory with the original tab positions, even if you change the tab
positions on the typewriter before printing.
When the memory is full, a buzzer will sound to warn you of the fact. No more data
can be stored, but normal typing may be continued.
When there is data previously stored into the memory, any new text stored will be
added on to the end of that text.
Printing text from memory
STORE
PRINT
Data stored in the text memory may be printed directly from memory using the print
mode. First set the margins, line spacing, and impact, then hold down the [CODE] key and
press the [PRINT] key to print the stored text. When the printout is complete, your
typewriter will automatically leave the print mode.
Printing may be stopped in progress by pressing the [END] key. Printing will cease
immediately and the carrier will return.
Notes:
I. Printing may betemporarily suspended while in progressbypressingthe [SPACEBAR].
The carrierwill complete the line being printed when the [SPACEBAR] was pressed,
carrier return, and then pause (the three PITCH LEDs will blink during the pause
intewal). Printing may be resumed by holding down the CODE key and pressing the
[PRINT] key again.