Celestron SkyScout car gps receiver - Manual (Page 12)

Updating your SkyScout (continued)
To Install the USB drivers:
1. Use the included USB cable to connect the SkyScout to your computer.
2. Power on the SkyScout.
3. Once on, your computer should recognize the SkyScout as a new device and display the
screen below.
4. Insert the SkyScout CD into your computer’s CD-ROM drive.
5. Select the option “Install the software automatically”.
6. Press the Next button to continue.
7. Once the drivers have been successfully installed, press the Finish button to complete.
Installing SkyScout Update Program
1. Insert the SkyScout CD into your computer’s
CD-ROM drive. An interactive menu should
appear on your computer screen.
a) If CD-ROM does not auto launch then double
click on “My Computer”.
b) Double click on the drive that contains the
CD-ROM.
c) Then launch the program “StartMe.exe”.
2. When the following opening screen appears,
select Install SkyScout Update Program.
3. This will launch the installation wizard that will
guide you through the setup of the program.
4. Once installed, click the icon created on your
computers desktop to start the program.
5. Press the Help button on the SkyScout interface
screen and follow the on-screen instructions for
updating both the SkyScout firmware and the
SkyScout Update Program.
11