Ctcss operation, Installing the ctcss board, Lift – Uniden UBC9000XLT User Manual
Page 48
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
CTCSS Operation
This section applies only if you are installing and using an optional
CTCSS Tone Board with your scanner.
Installing the CTCSS Board
Installing the CTCSS Tone Board is a simple procedure, and requires only
a few minutes following the steps below.
I
CAUTION:
Be sure to turn the scanner offend disconnect the power
cord before attempting to open the scanner.
1. Remove the five screws from the top cover.
Lift
2. Carefully lift the cover up from the back of the unit and turn it to
the left - being careful not break the speaker wire.
3. Stand the cover on its left side panel.
(Continued, next page)
45
Advertising