Programming channels, Programming by manual entry – Uniden UBC220XLT User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Programming Channels
Before you can scan, you must program the channels within a
bank. You can store one frequency per channel, up to 200
channels.
Note; If
-m-t
appears on ihe display (keypad Locked),
unlock the keypad by pressing and
holding (^)
until
w* disappears and you hear two beeps.
There are two ways to program a channel:
■
Manually select a channel and frequency, using the
numenc keypad.
■
Search a band to find an active frequency, and then
directly store it into a selected channel. (See the Search
section, page 21).
Programming By Manual Entry
1. Select a desired frequency.
Example
: Program 125.2500 MHz into Channel 18.
2. Make sure the scanner is not scanning or searching.
3. Otherwise, press to stop SCANNING or deactivate
SEARCH MODE.
4.
Press (lXD@ ’o go to Channel 18.
5.
Enter the frequency number using the numeric keypad.
(Be sure to include the decimal point.) As soon as you
enter the first digit of the frequency, the channel number
begins to blink.
© ® ® ® ® ®.
riANK 2
70:/<?5.^5
HOLD
IWou make a mistake and want to dear the entry, press
(5) twice and re-enter the frequency.
14