Kenwood SPECTRUM 755 AV - Manual (Page 13)

Coimectmg your
components
Important:
Please wait until you’ve connected.. .
all of the cables before plugging any
of the components into.AC wall ...
outlets and turning them on, , ;,
Connecting your
speakers
Connect your speakers .first. You'll _
have an easier.time getting to .the
connections oa the backs of the
components before you connect, all
of the other cables'.
1 Place the speakers in their
approximate locations first then
leave a little extra speaker wire
so you can fine-tune their loca­
tions.
2 Use the speaker wire supplied
with the speakers: If you need
longer wire; buy speaker-wire
that is 18-gauge or thicker.
Remember, the sm.aller.the..
number, the thicker the wire: . .
18-gauge wine is thicker than.
20-gauge. . ^ ,
A few tips
• To save you time, weVe. . .
removed the insulation from the
ends of the speaker wire, we -
supplied. _ .
• When connecting speaker wires,
be sure to connect positive.
connections to each other and
negative connections.to each ..
other. Connecting positive to...
negative (+ to -) or negative to
positive (- to +) can cause poor
sound quality.
• Never allow the positive and .
negative speake r wi res to to u ch .
each other. Touching wires can. ..
cause a short circuiU which could
damage your electronics.. ^
Left and right front speakers
Connect the left and right speakers ■
to the 'Front Speakers' jacks on the ■
receiver.
Surround speakers
Connect the .surround speakers to
the 'Surround Speakers' jacks on the
receiver,
Center speaker
Connect the center speaker to. the
‘Center Speaker’, jack on the
To connect the wire:
1 Unlock the..lever . .2 Insert the wire 3 Lock the lever
13.