Flyzone FLZA4022 - Manual (Page 12)

12
❏
4. With the system still on, make sure the ailerons are
centered and aligned with the wing tips. If necessary, apply a
few clicks of aileron trim to get the ailerons centered. If more
than a few clicks of trim are required, or if you cannot get both
ailerons neutralized, a small screwdriver may be used to pop
off one or both fl ap servo covers to access the pushrods.
Adjust the pushrods in the connectors to get the ailerons
centered. When fi nished, replace the cover, press into position,
and hold in place with tape or a dab of glue.
FINAL FLIGHT PREPARATION
Check the Control Throws
Because the servos and pushrods are factory-installed
the control throws should already be correct, but because
of the effect the control throws can have on a model, it’s
always a good idea to check them anyway.
FULL
THROTTLE
RUDDER
MOVES
RIGHT
ELEVATOR
MOVES DOWN
RIGHT AILERON MOVES UP
LEFT AILERON
MOVES DOWN
4-Channel Radio Set Up (Standard Mode 2)
❏
1. Confi rm that the controls are responding in the correct
direction according to control inputs from the transmitter. If
necessary, use the servo reversing program in your transmitter
to change the servo direction of any controls that are moving
the wrong way.
❏
2. If your de Havilland Beaver is confi gured with wheels,
use a small box or something similar to prop up the bottom
of the fuselage under the tail so the wings and stab are level
(or nearly level).
❏
3. Measure and set the control throws according to the
measurements below. The throws are measured at the widest
part (front-to-back) of each surface.