Flyzone HCAA41 - Manual (Page 9)

9
PREPARE THE TRANSMITTER
Locate the antenna and screw it into the top of the
transmitter. The transmitter that controls your airplane
requires power, in the form of eight “AA” batteries.
To install the batteries, remove the battery cover on
the bottom of the transmitter. Pull the battery holder
out of the transmitter case and install eight new “AA”
batteries, following the diagram on the holder. Reinsert
the battery holder in the transmitter case. Reinstall
the battery cover on the bottom of the transmitter
case. Switch on the transmitter and check the LED
on the front. If the LED is green, it is safe to fl y. If the
LED is red, you need to install fresh batteries.
CAUTION!
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (NiCd or NiMH) batteries.
CHECK THE CONTROL DIRECTIONS
Be sure your transmitter has fresh “AA” batteries
installed (not included). Turn on the transmitter and
center the trims tabs. Staying clear of the propeller,
open the canopy from the SkyFly 2 and connect the
battery to the receiver/ESC.
If necessary, adjust the control surfaces by loosening
the nylon screw connectors and moving the control
surfaces so that the elevator is aligned with the
stabilizer and the rudder is aligned with the fi n.
Re-tighten the screw connectors.