Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 136)

136 <Appendix>
Timer setting
●Up timer/down timer setting
Move the cursor to the [MODE] item and
touch the RTN button to switch to the data
input mode.
Select the mode by scrolling the touch sensor
and touch the RTN button.
[UP]: Up timer
[DOWN]: Down timer
[HOUR]: Hour mode timer
●Timer time setting
Move the cursor to the [ALARM] item and
touch the RTN button to switch to the data
input mode.
Set the time by scrolling the touch sensor.
[00]:[00]:[min]:[sec]
Touch the RTN button to end the adjustment
and return to the cursor mode.
●Switch setting
Move the cursor to the item of the switch you
want to set, access the switch setup screen
by touching the RTN button. Select the switch
and ON direction.
[For a detailed description of the setting method, see [Switch
Setting Method] located on the next page.]
[START]: Start switch
[STOP]: Stop switch
[RESET]: Reset switch
●Memory setting
Move the cursor to the [MEMORY] item and
touch the RTN button to switch to the data
input mode.
Select the mode by scrolling the touch sensor
and touch the RTN button.
[OFF]: Memory function OFF
[ON]: Mode where the timer is not reset when
turned power off and switched the model.
●A mode which sounds an alarm each minute
can be selected.
Change the setting using the "" button (or
"" button).
"": Alarm sounds each minute of the time
elapsed from timer start. (Conventional
mode)
"": Alarm sounds each minute of the time
remaining up to the alarm time.
Timer operation
● Timer ST1 and ST2 are started/stopped by
pre-selected start/stop switch.
● To reset a timer, operate the pre-selected
reset switch, or move the cursor to the [RESET]
display on the timer screen and touch the
RTN button.