GME TX3520 - Manual (Page 28)

PA G E 2 8 I n s t r u c t I o n m A n uA l t X 3 5 1 0 / t X 3 5 2 0 / t X 3 5 4 0
CHANNEL
remote Head
main unit
the remote head cable uses an 8 pin telephone style
connector. Plug the cable from the remote head into the socket
in the Front of the mAIn unit. Plug the mIcroPHonE (6 pin
plug) into the front of the rEmotE HEAD unit. (Alternatively
the microphone can be plugged into the rear microphone
socket on the main unit.
NOTE: the remote head socket (8 pin) is different to the
microphone socket (6 pin). Do not attempt to plug the
microphone into the front of the main unit as it will not fit
MICROPHONE
the tX3510 and tX3520 uses a standard microphone fitted
with a 6 pin telephone style plug. the standard microphone
will fit the 6 pin socket in the front of the tX3510 and tX3520
radio panels. Alternately the standard microphone can be
plugged into the microphone socket on radio’s rear panel..
If connecting the microphone to the rear socket, an optional
extension cable lEm6P is available if required to bring the
microphone connection to a more accessible location.
the tX3540 uses a controller microphone which has an 8 pin
telephone style plug. this microphone can only be plugged
into the 8 pin socket on the front of the tX3540 main unit.
the controller microphone cannot be plugged into the rear
microphone socket.
Fitting the standard microphone
Front
1. the front microphone cover is a press fit. to remove, simply
insert the end of a paper clip or similar into the small slot
in the edge of the cover and lift the cover away from the
panel. retain the cover in case you require it later on.
2. Position the microphone plug so the plastic tab faces
downwards, and press the plug into the socket until
it ‘clicks’.
CHANNEL
PRIORITY SQL LVL
PUSH PUSH
Plastic tab
3. Gently press the rubber strain relief into the hole
surrounding the socket so that the slot around the strain
relief fits neatly inside the lip of the hole.
Rear
1. the rear microphone cover hinges from the top. simply lift
the cover from the bottom. the cover will remain connected
to the chassis.
2. Position the microphone plug so the plastic tab faces
downwards, and press the plug into the socket until
it ‘clicks’.
lift microphone
cover
Plastic tab
Removing the microphone
1. For front panel connections, first squeeze the rubber strain
relief near the front panel to disengage the slot, and slide
the strain relief back along the microphone cord.
2. For both connections, squeeze the plastic tab on the
microphone plug towards the plug to unlock it while gently
pulling the plug outwards. If the plug does not come out
easily, the tab has not released correctly and should be
squeezed again.