Great Planes Factor 3D ARF - GPMA1552 - Manual (Page 7)

7
❏ ❏
6. Install and then remove a #2

3/8" [10 mm] screw
into each of the holes you have drilled. Apply a drop of thin
CA into the holes to harden the threads. Once the glue has
cured, secure the control horn to the aileron with the screws.
❏ ❏
7. Slide a silicone clevis retainer over the clevis. With
the aileron servo and the aileron centered, mark the aileron
pushrod where it crosses the aileron servo arm. Make a 90°
bend at the mark. Cut the pushrod 3/8" [9.5 mm] past the bend.
Attach the pushrod to the aileron servo arm with a nylon Faslink.
❏ ❏
8. Locate a 1/8"

½" [ 3

13 mm] nylon pin. Glue it into
the hole at the trailing edge of the root rib. Approximately ¼"
[ 6 mm ] of the pin should extend from the root rib.
❏
9. Repeat steps 1- 8 for the left wing panel.
ASSEMBLE THE FUSELAGE
Install the Main Landing Gear
❏
1. Attach the two main landing gear legs to the fuselage
with four 4 - 40

3/8" [3

10 mm] screws, #4 lock washers
and #4 fl at washers.
You will complete the installation of the wheels and wheel
pants in a later step. Installing the landing gear legs now will
make handling the fuselage easier during the assembly of
the fuselage.
Install the Elevator & Rudder Servos
❏
1. Install a 16" [ 400 mm] servo extension to both the elevator
servo and the rudder servo. Secure the extension to the lead
with tape, a piece of shrink tube (not included) or some other
method to keep them from coming unplugged.
❏
2. Inside the fuselage there is a string running through the
fuselage from the back to the front. The string is taped in place