Great Planes Pluma 3D Bipe ARF ARF - GPMA1130 - Manual (Page 14)

14
❏
4. Locate the two 1 x 145mm front wing supports. Route
each through its respective hole in the LE of the upper wing
and into the holes in the forward fuselage. Before you glue
them in place, check to see that the upper wing is still aligned
with the horizontal stab. When you’re satisfi ed, glue the front
supports in place.
❏
5. With the wings square, place a drop of thick foam-safe
CA at the junction of the main wing braces. CA accelerator
is helpful here.
❏
6. After the CA cures, pick up the plane and check all the
wing brace glue joints. Go back and add CA to each side of
every joint.
Install the Aileron Servo
❏
1. Turn the model over. Locate the two remaining control
horns. Glue them into the slots provided in the bottom of
each lower aileron.
❏
2. Center your aileron servo using your radio.
❏
3. Locate the plastic servo arm provided in the kit.
Remove the servo arm from your servo. Mount the servo
arm to your standard servo arm with the arms swept forward.
Use the supplied 1.5 x 4mm self-tapping screws to install the
extended arm to the standard servo arm. Install the screws
from the bottom so that the heads of the screws face the
body of the servo. Note: The output shaft of the servo will
face toward the front of the model.
❏
4. Install your aileron servo with the output shaft facing
forward. Remember to install the servo arm screw.