Heli-Max HMXE1008 - Manual

❏
1. Position the blade as shown above and test fi t the top
reinforcement on the blade.
❏
2. Turn over the blade and test fi t the bottom reinforcement.
❏
3. Once you have verifi ed everything fi ts properly, mix up
some 30-minute epoxy and apply it to the exposed wood on
the root of the blade. Install the top and bottom reinforcements
as shown above. Double check your work to verify the
reinforcements are installed properly. Install and tighten the
two 2.6mm screws into the reinforcements as shown.
❏
4. Use a paper towel dampened with isopropyl alcohol to
remove the excess glue from the blade. Before the epoxy sets,
install the blades into the grips to clamp the reinforcements
down onto the blade. Once the epoxy has set, you can
proceed to use the blades.
Warning: The blade root reinforcements must be glued to the main blades. Please inspect the blades for damage before
assembling them. Do not exceed 1700 RPM with the wood blades or failure may occur. Blades are considered consumable
items and should be discarded if there is any sign of damage.
600mm MAIN ROTOR BLADES
INSTRUCTIONS