IC Realtime Specialty: 4-CH Mobile DVR - Manual (Page 60)

60
5.3.3 Schedule
Please refer to chapter 4.4 schedule.
5.3.4 RS232
RS232 interface is shown as below. There are five items. See
X363H363H363H333H333H333H340H303H
Figure 5-8
z Function: There are various devices for you to select. Console is for serial port or min-end
platform to upgrade program. Keyboard is for you to use special keyboard to control current
device.
z Baud rate: You can select proper baud rate.
z Data bit: You can select proper data bit. The value ranges from 5 to 8.
z Stop bit: There are three values: 1/1.5/2.
z Parity: there are three choices: none/odd/even.
System default setup is:
z
Function: Console
z Baud rate:115200
z Data bit:8
z Stop bit:1
z Parity: None
After completing all the setups please click save button, system goes back to the previous menu.
Figure 5-8
5.3.5 Network
Here is for you to input network information. See
X364H364H364H334H334H334H341H304H
Figure 5-9.
X
z IP address: Here you can input IP address.
z DHCP: It is to auto search IP. When enable DHCP function, you can not modify IP/Subnet
mask /Gateway. These values are from DHCP function. If you have not enabled DHCP
function, IP/Subnet mask/Gateway display as zero. You need to disable DHCP function to
view current IP information. Besides, when PPPoE is operating, you can not modify
IP/Subnet mask /Gateway.
z TCP port: Default value is 37777.
z UDP port: Default value is 37778.
z HTTP port: Default value is 80.
z Max connection: system support maximal 10 users. 0 means there is no connection limit.
z Transfer mode: Here you can select the priority between fluency/video qualities.