IC Realtime 600TVL / 650TVL 23X High Speed PTZ Camera with 250' IR - Manual (Page 24)

17
ADDR ： 001-H
BAUD RATE ： 9600
PARITY ： NONE
PROTOCOL ： PELCO-D
MODEL ： SD6663-HN
TEMP : 032℃
SOFTWARE ：v1.04.3
BACK
EXIT
z FACTORY DEFAULT: Restore dome factory default setup. Please move the cursor to the option and
then click confirm button until you see O.K. Now you can see the IP dome begin rebooting to restore
factory default setup.
z RESTART: Reboot the speed dome.
z BACK: Go back to the previous menu.
z EXIT: Log out system menu.
4.4.1.1 Initialization information
Move the cursor to INITIAL INFORMATION and then click confirm button, you can see the above interface.
Here you can view dome basic information.
4.4.1.2 Address Information
Move the cursor to SITE INFORMATION and then click confirm button.
z
ADDR TYPE: There are two options: soft and hard. Please use the left/right button on the keyboard or
in the speed dome terminal menu to set.
z ADDR-HARD: It is an address you set in the dial switch. You can not modify it through software.
z ADDR-SOFT: You can set address via software. It is to say, you can use menu to modify dome address.
The value ranges from 1 to 255.
z BACK: Go back to the previous menu.
z EXIT: Log out system menu.
4.4.1.3 System Time Setting
z Move the cursor to SYSTEM TIME SETING and then click confirm button, you can go to the third
submenu. Please use the left/right button on the keyboard or in the speed dome terminal menu to set.
After completed setup, please click confirm button to save current setup. After you see speed dome
menu displays OK, you can see the setup is valid now.
4.4.2 Display Setting
ADDR TYPE : HARD
ADDR-HARD : 001
ADDR-SOFT : 001
BACK
EXIT
YEAR : 2009
MONTH : 001
DATE : 017
WEEK : SUNDAY
HOUR : 013
MINU： : 052
SAVE
BACK
EXIT