IC Realtime 2 Megapixel Mini Network PTZ Dome Camera (ICIPP2012S) - Manual (Page 12)

4
Figure 2-3
There are two dial switch buttons on the PTZ. You can use them to set speed dome address,
baud rate, and parity respectively. It is 1 when you set the button as ON.
For the protocol dial switch, you can refer to the following sheet. 1 is the lowest bit and the 8 is
the highest bit.
Please note the intelligent speed dome can automatically recognize the industrial
standard protocol, PELCO-D. PELCO-P. Usually you do not need to set the protocol.
2.4.2 Baud Rate and Parity Setup
For the dial switch button 1-4. 1 and 2 is to set baud rate. 3 and 4 is to set parity. Please refer to
the following figure for detailed information. See Figure 2-4.
Figure 2-4
Please refer to the baud rate sheet for detailed information.
1 2 Baud Rate
OFF OFF 9600bps
ON
OFF 4800bps
OFF
ON
2400bps
ON ON 1200bps
Please refer to the parity setup sheet for detailed information.
3 4 Parity
OFF OFF NONE
ON
OFF EVEN
OFF ON ODD