Intellijel Cylonix Shapeshifter v1.03 User Manual
Page 46
46
15. Click on the “Memory” tab on the left hand side. In the “Memory Type” menu on the right hand
side, choose “EPCS (100000h WORDS, 2MB)”. This will select the configuration EPROM on the
Shapeshifter board.
16. Because of the way in which the EPROM is written, you first have to erase the entire EPROM.
Once you do this, your Shapeshifter board will no longer be functional, so take a deep breath,
and then press the “Chip Erase (30 sec.)” button. The erasing process actually takes about 2
minutes, not 30 seconds.
17. In the “Sequential Write” section click on the box “File Length” and then click on “Write a File to
Memory”. Select the shapeshifter_firmware_modified.bin file.
18. A progress window will appear. The writing process will take about 16 minutes (!). Do not
disconnect the board from the computer during this process; otherwise you will have to restart
the writing process. Once the writing has been completed your Shapeshifter board will be
updated and ready to go!