Interlogix MCR300-1T-2S - Manual (Page 9)

- 9 -
2.3 Rear Panel
The rear panel of the Gigabit Media Converter indicates one DC jack, which accepts input power with 5V DC 2A.
Figure 2-3-1: One DC jack for DC power input
Power Notice:
Power Information: the power jack of MCR300-1T-2S is with 2.5mm in the central post and required +5VDC power input. It will
conform to the bundled AC-DC adapter and IFS’s Media Chassis. Should you have the issue to make the power connection, please
contact your local sales representative?
Please keep the AC-DC adapter as spare parts when your MCR300-1T-2S is installed to a Media Chassis.
2.5mm
DC Receptacle 2.5mm
+5V for each slot
DC receptacle is 2.5mm wide that conforms to and matches the Gigabit Media Converter 2.5mm DC jack's
central post. Do not install any improper unit, model of the Gigabit Media Converter.
The device is a power-required device, it means, it will not work till it is powered. If your networks should active all the time, please
consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network data loss or network downtime.
In some area, installing a surge suppression device may also help to protect your Gigabit Media Converter from being damaged by
unregulated surge or current to the converter or the power adapter.
2.4 Side View
The side panel of the Gigabit Media Converter indicates One DIP switch for set 3-Port switch mode or 2-Port Redundant mode,
“ON” for operate at 2-Port Redundant mode. And “OFF” to operate at 3-Port switch mode.
Figure 2-4-1: MCR300-1T-2S Side Panel