Desa Tech CGEFP33PR - Manual (Page 3)

3 107570
OWNER’S MANUAL
For more information, visit www.desatech.com
PRODUCT
IDENTIFICATION
LOCAL CODES
Install and use fireplace with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code, ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
1. With utility knife, cut the carton all the
way around above the staples on the
bottom tray. Lift the carton off the
heater. Remove packing.
Note: The
hood is located in the packing on the
right hand side of the fireplace. Lift the
fireplace off the bottom tray.
2. Locate two screws above top corners
of the fireplace screen. Remove and
discard these screws. Lift fireplace
screen up and pull out to remove.
3. Remove protective packaging applied
to logs, fireplace floor assembly, and
fireplace.
4. Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought fireplace.
Figure 1 - Fireplace Floor Assembly (EFP33PR Shown)
Figure 2 - Fireplace
Top Louver
Assembly
Firebox Hood
Bottom
Louver
Assembly
Screen
Assembly
Top Outer Casing
Firebox Support
Blower Assembly
(Optional)
Log Set
Wall
Switch/
Plate
Piezo
Ignitor
Remote
Control
Manual Override
Handle
Manual Ignition
Bypass Switch
SAFETY
INFORMATION
Continued
16. Operating fireplace above elevations of
4,500 feet could cause pilot outage.
17. To prevent performance problems, do
not use propane/LP fuel tanks of less
than 100 lbs. capacity.