Ss ee tt uu pp ii nn ss tt rr uu cc tt iioo nn ss – Intex Pool Ladder For 52in (132 cm) model 2012 User Manual
Page 6
92PO
SAVE THESE INSTRUCTIONS
Page 6
(92PO) 52" 2-SECTIONS POOL LADDER ENGLISH 7.5” X 10.3” PANTONE 295U 10/13/2011
English
SS
EE
TT
UU
PP
II
NN
SS
TT
RR
UU
CC
TT
IIOO
NN
SS
LADDER SETUP
TOOLS REQUIRED: One (1) Phillips screwdriver
One (1) pair of pliers or a small adjustable wrench
IMPORTANT: Do not fully tighten fasterners until last assembly operation.
A
B
B
A
B
1
A
B
A
B
WARNING
ASSEMBLE THE LEGS BEFORE INSTALLING THE LADDER STEPS.
FAILURE TO ASSEMBLE THE LEGS BEFORE INSTALLING THE
STEPS MAY ALLOW THE LEGS TO SEPARATE FROM THE LADDER
DURING USE, POSSIBLY RESULTING IN SERIOUS INJURY OR DEATH.
WARNING
INCORRECTLY CONNECTED PARTS MAY RESULT IN AN UNSTABLE
LADDER OR LADDER FAILURE WHICH CAN CAUSE FALLING AND
PERSONAL INJURY OR DEATH.
1. IDENTIFY PARTS: It is very important to lay out the parts correctly and
identify which parts connect together before starting the assembly.
Although some parts look alike, they are not always interchangeable.
Refer to the parts list.
2. LEG ASSEMBLY (refer to figure 1):
There are two straight upper leg
parts (7) marked “A” and two
J-shaped lower leg parts (9) also
marked “A”.
There are also two straight upper leg
parts (8) marked “B” and two lower
J-shaped leg parts (10) marked “B”.
The markings are located on the
top plastic caps at the end of each
leg part.
Connect the “A” upper leg parts with
“A” lower leg parts as follows:
• Align the groove on the lower leg
part with the notch on the upper
leg part - see figure 1.
• Insert the lower leg part into the
upper leg part and then turn it
clockwise to lock it in place.
• Verify that the plastic step mounting fixtures are aligned and facing the
same way on upper and lower leg part. Also lift the upper leg part and
verify that the lower leg part is properly inserted/locked and doesn’t fall
out.
Repeat these steps to connect the “B” upper leg parts with “B” lower leg
parts accordingly. NOTE: DO NOT MIX “A” PARTS WITH “B” PARTS!
You now have two complete “A” legs and two complete “B” legs.