Keri Systems EntraGuard Platinum Quick Start User Manual
Entraguard, Platinum telephone entry controller, 0 drawings
EntraGuard
®
Platinum Telephone Entry Controller
Quick Start Guide
Page 1 of 28
P/N: 01969-001 Rev. C
This quick start guide provides, basic installation information, drawings, first time power-on instructions, and short
descriptions of key terms and concepts for installing the EntraGuard Platinum Telephone Entry controller. The
EntraGuard Platinum controller may be used alone or may be connected to a PXL-500/PXL-500G-1 network. For
instructions on how to install a postal lock, see the EntraGuard Platinum Postal Lock Installation Application Note (P/N
01964-001).
NOTE: It is the responsibility of the installation organization to have only technically qualified personnel performing the
installation.
Section 01 - Drawings
Section 07 - Powering the Controller for the First Time
Section 08 - Setup Controller
Section 03 - Cable Requirements
Section 09 - General Information on Inputs
Section 04 - When Installing Controllers
Section 10 - General Information on Safety versus Security with Door Locks
Section 05 - Wiring Instructions
Section 11 - Contact Keri Systems
1.0
Drawings
1.1
EntraGuard Platinum Front Panel
Figure 1: The EntraGuard Platinum Telephone Entry Controller - Front Panel
Document Outline
- 1.0 Drawings
- 2.0 Specifications
- 3.0 Cable Requirements
- 4.0 When Installing Controllers
- 5.0 Wiring Instructions
- 5.1 Terminal Blocks
- 5.2 Connecting the Earth Ground and the 12 VDC Power
- 5.3 Connecting a Door Status Input
- 5.4 Connecting a Request to Exit (RTE) Input
- 5.5 Connecting a General Purpose Input
- 5.6 Connecting an Alarm Output Relay
- 5.7 Connecting a Fail-Safe Lock Output Relay
- 5.8 Connecting a Fail-Secure Lock Output Relay
- 6.0 Communication
- 7.0 Powering the Controller for the First Time
- 8.0 Setup Controller
- 9.0 General Information on Inputs
- 10.0 General Information on Safety versus Security with Door Locks
- 11.0 Contact Keri Systems