Lippert Components Ground Control 3.0 - Manual (Page 11)

Rev: 01.30.2015
Page 11
Ground Control 3.0 Service Manual
Component Replacement
NOTE: After replacing any of these components, you will need to "home" the jacks. See the corresponding
sections for instructions.
Landing Gear Replacement
1. Remove existing landing gear from the unit by removing the carriage bolts and nuts in the brackets
that are holding the landing gear in place.
2. Using the new carriage bolts and nuts, mount the new landing gear in the brackets so that the tabs
on the new landing gear are positioned between the mounting brackets as shown in Figs. 16 and 17.
Tighten the nuts on the carriage bolts until the bracket opening is less than 2 ½ ”.
3. Connect the wire harnesses to the landing gear motor wires and run the harnesses to the
compartment where the controller will be mounted.
NOTE: LCI recommends zip-tying the harnesses tight against the landing gear motors to prevent damage to
the harnesses.
Tab
Tab
Landing Gear
Fig. 16 Fig. 17
Main Frame Rail