Motion Pro 08-0213 - Manual

INSTRUCTIONS
Process Black
White White/Black MOTION PRO, INC. LOGO
Motion Pro, Inc.
867 American Street
San, Carlos, CA 94070
Tel: 650.594.9600 Fax: 650.594.9610
www.motionpro.com
Motion Pro Swing Arm Bearing Installation Tool P/N 08-0213
I08-0213 1/2013
Designed for use on late model off-road motorcycles from 1990 to present.
This tool has the necessary drivers to fi t the main swing arm needle bearings.
IMPORTANT MAINTENANCE NOTE: CLEAN AND LUBRICATE THE THREADED ROD BEFORE EVERY USE.
1. Begin by selecting the correct size driver (see chart) and inserting it into the swingarm
bearing. Note: The driver OD must be slightly smaller than the ID of the swing arm.
2. Install the threaded rod through the driver and swing-arm bearing and slide the unit,
(bearing fi rst) into the swing arm until there is an equal amount of thread on each side.
3. Slide the thrust bearing onto the threaded rod next to the driver (with the rounded
shoulder side facing the driver) and then slide one of the two solid washers (largest
that will fi t) onto the threaded rod on the opposite side of the swing-arm.
4. Complete the tool assembly by threading a nut onto each side of the threaded rod.
5. Check the tool to insure that it is aligned squarely to the swing-arm bearing and begin
tightening the nut outside the thrust bearing.
6. Continue to monitor the bearing alignment until the bearing is seated in the exact
location required by the manufacturer’s specifi cation.
IMPORTANT:
Be sure to drive the bearing to the exact location required by the manufacturer’s
specifi cation. If in doubt, measure the location of original bearings before their removal.
HONDA
22X28 D
22X29 D
KAWASAKI
20X27 F
22X28 D
22X29 D
KTM
22X28 D
HUSABERG
22X28 D
SUZUKI
20X27 F
21X27 E
22X28 D
22X29 D
YAMAHA
20X27 F
22X27 E
22X28 D
BEARING SIZE USE DRIVER
CONTENT LIST
1. Threaded Rod
2. Thrust Bearing
3. D, E and F Drives
4. Large Washer
5. Small Washer
6. Two Nuts
THREADED
ROD
THRUST
BEARING
NUT
NUT
LARGE
WASHER
SMALL
WASHER
DRIVERS