New England Arbors VA94429 - Manual

Check Boxes for These Contents (2 Boxes)
In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346, ext #20 (Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. Lamp Post Top (1) 5” x 5“x 58”
2. Post Coupler (1)
3. Lamp Post Bottom (1) 5” x 5“x 14”
4. Post Cap (1)
5. Base Molding Trim Cap (1)
6. Base Molding Post (1)
7. Base Molding Bottom Insert (1)
8. 1-1/2” Screws (4)
9. Vinyl Weld Glue (1)
10. Post Trim (1) - Included with the Sturbridge Lamp Post
Tools You Will Need
• Wheelbarrow or bucket (to mix concrete)
• Tape Measure
• Level
• Shovel
Purchased Separately
• Lamp.
• 4x4 Pressure treated lumber. - 8’ long
• Two bags of pre-mix concrete. *
* Strongly recommended for the stablility of this product.
General Information
• Read Instructions through carefully before beginning assembly.
• When handling components, place on a non-abrasive surface
(i.e. shipping box)
to avoid scratching.
• We recommend an area approx 10’x 8’ for unobstructed handling.
Important Note:
• Please refer to local codes before installing outdoor lighting. UF-rated cable should be used for
underground wiring and all materials should be approved by the Underwriter’s Laborator (UL).
New England Arbors assumes no liability for errors, ommissions or the outcome of any project.
The Madison/Sturbridge Lamp Post
Please read through before starting assembly.
A S S E M B LY I N S T R U C T I O N S
1
1
Ver 3/OCT 2010
8
Not to Scale
74 in.
24 in.
5 in.
6 in.
72 in.
3 in.
4
9
Madison Lamp Post Sturbridge Lamp Post
10
6
7
3
2
5