Coleman ELITE WEATHERMASTER 2000001588 - Manual (Page 2)

Self-rolling Windows
CAUTION: “Springs” may have sharp edges. Handle with care to avoid
injury. Keep out of reach of children.
NOTE: Carefully unroll metal “springs” stored in bag with stakes. The color
marking on each “spring” should match the color of the fabric “flag” sewn
to the window or door sleeve opening. (Fig. 24)
1.
Locate sleeve(s) in window panel, open hook &
loop fastener; then insert “spring(s)” with match-
ing color marking. (Fig.24 & 25)
NOTE: When inserting into the sleeve(s), the
color marking on the “spring(s)” should always
face the operator.
2. Close hook & loop fastener to secure.
3. Before unzipping and opening the window,
push in at top to engage “spring(s)” to activate
the self-rolling feature. (Fig. 26)
4. Unzip to allow the window panel to roll down
automatically; zip back to close window panel.
(Fig. 27 & 28)
NOTE: Repeat steps above for inserting the color
matching “spring(s)” into sleeve(s) for the rest of
the windows.
3. Insert tapered metal tip on Awning
Pole into grommet located on web
strap clipped to center Leg Pole.
(Fig. 19)
4. Go to opposite center Leg Pole on
other side of door and gradually
apply pressure to the pole forming
an arch. Insert metal tip into the
grommet.
5. Locate all hook & loop fasteners on underside
of Rainfly and wrap around Leg Poles and
Awning Pole locations. (Fig. 20)
Cooler Access
The smaller zippered opening at the side of tent is
designed for added ventilation and easy access to
your beverage cooler.
1.
To use as a vent, unzip flap to expose screen.
2. To use as a cooler access, unzip other flap to
make an avenue to bring beverages into tent.
(Fig. 32)
STITCH LINE
Attaching Room Divider
1. Divider Panel can be installed through
center of the tent by inserting the
toggles through
top and bottom
fabric loops as
shown.
(Fig. 29 & 30)
To Store
1. All “springs” must be rolled up and placed in bag with stakes.
2. All poles and stakes must be placed in the storage bag to prevent
damage to the fabric items placed in the carry case.
3. Make sure tent is clean and dry before placing in carry case.
4. Remove rainfly, spread out on floor of tent, then unzip door & vents
before taking tent down for storage.
5. Neatly fold tent to width of pole storage bag, place on tent, roll
tightly, and place in carry case.
5. Store in a clean, dry area.
Electrical Cord Access
1. Unzip the access panel in the lower
left corner of tent and bring in an
electrical cord.
NOTE: Use only UL approved cords
rated for outdoor usage. (Fig. 31)
Fig. 29
Fig. 32
Fig. 31
Fig. 22
Fig. 20
Fig. 23
Fig. 19
Grommet
End Leg
Pole
Location
7. Loop ends of guylines over stakes, stretch tight, then hammer into
ground at an angle as shown. (Fig. 23 & 23A)
Awning Pole
To Attach Rainfly
1. Drape Rainfly over tent. Make sure seams on Rainfly are facing down
and centered over poles of the tent. (Fig. 17)
NOTE: Hook and loop fasteners, located on seams of underside of
Rainfly, should be centered over Ridge Poles.
Fig. 17
Rainfly
Door
Sleeve
Fig. 18 2. Assemble thin, black, shock-corded
Awning Pole with metal tips; then
insert through sleeve in Rainfly above
door. (Fig. 18) Awning
Pole
Sleeve
Fig. 30
Divider
Panel
Top
Fabric
Loops
Fig. 21
Center
Leg Pole
Location
23A
Guyline
Door
Window
Panel
Window Panel
Push in at top to
engage “spring(s)”
Color
Dot
Fig. 28
Fig. 24
Fig. 25
Sleeves
Sleeve
Fig. 27
Fig. 26
6. Insert metal hook on
elastic straps on
Rainfly into the hole
on each Leg Pole.
(Fig. 21 & 22)
Self-rolling Windows (continued)
CAUTION: All “springs” must be removed from sleeves before tearing
down tent to avoid damage to the tent fabric or part. To avoid injury,
carefully roll up “springs”. Keep out of reach of children. Store rolled
“springs in bag with stakes.
Color
“Flag”
Tent Lighting System
Your tent comes pre-wired with the Coleman ® Tent Lighting
System. See manual that came with the light and carefully read
all instructions before use then save for future reference.
Things You Should Know:
• Under certain conditions (cold weather, high humidity, etc.) condensa-
tion will form on the inside of your tent. Condensation is caused by water
vapor from your breath, perspiration, or any wet clothing inside the tent.
It is NOT LEAKAGE through the tent fabric. It can be minimized by
removing wet clothing from your tent and by providing good ventila-
tion through the tent.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping off
tree limbs can cause damage to the tent fabric and its coating resulting
in leaks or loss of flame-resistant properties.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use a separate storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER PULL ON
THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
• Tent poles should not be left telescoped together during storage.
• Do not leave your tent set-up for weeks at a time. Be aware that exposure
to ultraviolet rays from the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away
from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
Color “Flag”
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA • PRINTED IN CHINA
© 2008 The Coleman Company, Inc.
Coleman ® , , , and Weathermaster ® are registered trademarks of
The Coleman Company, Inc.
4010003995 (20081030)