Oakworks PerformaLift Series - Manual (Page 10)

7
INSTALLATION
INSTALLATION
LEVELING INSTRUCTIONS:
If Table Will Not Sit Flat on the Floor:
The tables are equipped with Leveler Feet that adjust to level the table
on uneven floors. To adjust the Leveler Feet to suit common floor dif-
ferences, you will need to use a 1 / 2 ” open-end wrench or an adjustable
wrench.
1/2” Open-end Wrench Leveler Foot
To Adjust the Leveler Feet:
1. Place the table in the location where you plan to use it.
2. Rock the table to determine if it is level with the floor. If the table
rocks back and forth at all, the foot that clears the floor when you rock
the table will need adjustment.
3. Adjust the Leveler Foot by first loosening the locking nut found just
above the rubber Leveler Foot with the open-end wrench.
4. Lower the adjustable rubber Leveler Foot until it meets the floor
snugly. Tighten the locking nut against the wooden leg of the table
with the open-end wrench to fix the Leveler Foot in position.
5. Rock the table again to be sure adjustments have stabilized the table.
If necessary make any additional adjustments in the same way.
Tighten Locking Nut Locking Nut
Locking
Nut