OmniSistem PR Chameleon - Manual (Page 6)

Chameleon manual.doc 6/12
Without connecting a controller with the projector, the projector will run in Stand-Alone mode controlled
by sound or auto programmes via setting the DIP switch as shown below.
When sound activating, the projector will change the colours according to the rhythm of the music.
You may rotate the audio sensitivity controller for the best receiving sound signal.
When running the auto programmes, the red LED is constant on. When running the sound activation,
the red LED will flashing according to the rhythm of the music.
Without using the controller, many projectors can run
synchronously by linking them with each other in the
Master/Slave mode.
Select one projector as the master without connecting
any cable to the projector’
s input, and set DIP switch
as shown on the right.
Regard the other projectors as the slaves, and set the
DIP switch as shown on the right.
Connect the master’
s output to the first slave’ s input,
and connect the first slave’ s output to the second
slave’ s input. The rest may be deduced by analogy.
Eventually connect the last slave’ s output to a DMX
terminator as shown in the figure above.
In the Master/Slave mode, all slaves will change
colors and gobos synchronously according to the
master.
MASTER / SLAVE SYNCHRO MODE
STAND-ALONE MODE