Casablanca Fan Company Modena II C10GXXM - Manual (Page 6)

6
CANOPY HATCH INSTALLATION
Step 10. Tuck the wires into the
canopy with the wire nuts pointed
upwards, so that the WHITE, GREEN
and BLACK wires are on opposite
sides of the canopy and all wires are
clear of the canopy opening.
Step 11. Install canopy hatch with the
last canopy screw and lock washer. To
do this, tilt the fan body away from
the hatch opening.Tighten the screws
firmly by hand only.
TILT THE fAN TO
INSTALL LAST
CANOpy SCREW
CANOpy
HATCH
CANOpy
SCREW
LOCK
WASHER
Step 12. Straighten the fan, then
check to ensure that there is no move-
ment between the canopy and ceiling
or Hang-Tru ball and downrod.
CANOPY ELECTRICAL CONNECTIONS
Step 9b. Wiring Connections
• GREEN leads from mounting plate and fan to
GROUND conductor of power source. Secure with
wire nut.
• WHITE wire from fan to white NEUTRAL wire in
ceiling fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to BLACK power wire in
ceiling outlet box. Secure with wire nut.
Step 8. To hang the fan body in the
canopy, hold the fan body firmly
and insert the ball into the canopy
opening. Check that no wires were
pinched. Rotate the fan body until the
slot in the nylon ball fits into the pin
opposite the canopy opening.
HANGING THE FAN
NOTE: The fan weight is 28 pounds.
Step 9a. Attach the fan wires to the ceiling fixture
outlet box wiring by twisting the bare ends of the wires
together and then securing with a wire nut. Test that the
connection is secure by pulling on the wire nut. Connect
in this order:
pIN SLOT
bALL
2 WHITE WIRES
2 bLACK WIRES
WIRE NUT
3 gREEN WIRES