Sonics FC - Manual (Page 12)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L F C P O W E R S U P P LY
11
CABLE CONNECTIONS:
Located at the rear of the power supply are the cable connections as
illustrated below. (The interconnecting cables will be supplied with your
system.)
1. A round, 12-pin RF cable that connects the welding press or converter to
the power supply.
2. An actuation cable that connects the power supply to a trigger source (refer
to wiring diagrams in Appendix).
3. The power line cord that plugs into the appropriate electrical outlet.
Once these connections have been made, the power supply is ready for
operation. If applicable, be sure to consult your welding press instruction
manual to insure that all connections on the press side are correct, and that
the press is ready for operation.
Also located at the rear of the power supply are the following:
4. fuses (fixed 0.5 amp),
5. fuses (based on requirements listed in “Power Specifications” table, p. 8),
6. fuses (based on requirements listed in “Power Specifications” table, p. 8),
7. outputs J7 (see wiring diagrams in Appendix),
8. outputs J8 (see wiring diagrams in Appendix),
9-12. optional.
❷
❶
❸
❹
❺
➏
❼ ❽
NOTE: Detailed wiring
diagrams are supplied
in the Appendix at the
back of this manual.
❿
❾
11
12
Fan
NOTE: To see a list of
converters that can be
connected to the power
supply, see the table on
the following page.