Trending Accessibility Adjustable fusion shower pan on wood joists - Manual (Page 5)

Installation Guide
www.trendingaccessibility.com [email protected]
5
for adjustable fusion shower pan on wood joists
Step 5
Install 2x stock to match existing joists, and block
around the perimeter of the Fusion Pan, around
the drain, and any unsupported edges of the
subfloor. This will ensure full support of Fusion
Pan, and existing subfloor.
2x Blocking
Step 6
Place the Adjustable Shower Pan into place. Make
sure that pan is level and fits snugly into place.
Step 7
We now want to make sure that the rotating
plate lines up with the waste line. First, Insert the
rotating plate onto the Adjustable Shower Pan. If
the drain position lands over a joist. Simple rotate
the plate until free of obstacles.
Step 8
Once plate is set in the desired location, mark
the orientation on the plate and the pan. This will
ensure that you have the plate properly aligned
when you go to reinstall it later. While in place,
measure the location of the center of the drain.
Take four measurements, from the outer edges of
the pan to the center of the drain. You will need
these measurements to position the center of the
waste line.
Mark the orientation of
the rotating plate