Cortelco 879015-TP2-27S - Manual (Page 13)

- 12-
Setting the Area Code
1. When you enter an area code or prefix using this feature, the phone will remove that code or prefix from
incoming numbers if a complete match of the prefix with the area code setting occurs when you dial from the
Callers List. This option allows you to enter only one area code of 1, 2, or 3 digits to be stripped off from the
incoming calls. Please note that this setting will not change the number stored in the Callers List but the
dialed number will have the area code or prefix stripped off. For example, if the number stored in the Callers
List is 8521234567 and the area code is set as 852, the displayed number changes as 123-4567 right
adjusted in the 7 segment array and when dialed, the dialed numbers 1234567.
2. When in this option, the display shows SET AREA CODE in the dot array and the previous set code or “ _ _
_” if not set before in the 7-segment array. The first digit or _ will be flashing. Use dial pad to enter the area
code.
3. For example, the previous set code is 513. 5 is flashing. Press 2. The code becomes 2 _ _ and the second
cursor is flashing. Press 4, 6 in sequence. The code becomes 246 and 2 is flashing. You may continue to
change the code or press “Menu” to save the area code 246 and enter the set long distance mode.
4. If you want to delete the area code setting, press Delete when you first enter the setting menu, that is, when
the first digit is flashing. Press Menu to save and enter set long distance code.
Set Time
Display shows the time/date and ENTER HOUR. The tens hour is flashing. Use dial pad to enter the hours.
Display shows ENTER MINUTES and the tens minute is flashing. Use dial pad to enter minutes. Display shows *
KEY SET AM/PM. Press * to set AM or PM. Press Menu to save AM or PM and enter set month.
Set Date
Display shows ENTER MONTH and the tens month is flashing. Use dial pad to enter the month. Display shows
ENTER DAY and the tens day is flashing. Use dial pad to enter day of the month and the phone will exit to idle
state after the day is entered.
Clear Message Waiting
Sometimes the Message Waiting Icon and the LED for message waiting flashes when there are no messages
waiting on your Voice Mail service. You can cancel the Message Waiting indication by pressing Delete for 5 sec in
idle state. Display shows CLR MSG WAITING. Press Delete again to clear the Message Waiting Icon and flashing
LED and exit to idle state. The LED will flash again when there are new messages waiting.