Viconics VC3000 Installation Manual - Manual (Page 2)

2 VC7300 Series-Installation Guide
I
NSTALLATION
There are three basic methods for installing the VC3000 transformer relay pack controller.
A) Inside an electrical cabinet of a fan coil unit
• Use the plastic mounting tabs to secure the unit to the inside of the electrical enclosure.
• Secure to the inside with screws.
• Cut one or both plastic mounting tabs if space is needed inside the enclosure.
• Install a low voltage or high voltage metal separator if required.
• Do not exceed the maximum rated temperature of the unit. (50 °C/122 °F)
IMPORTANT: ALL WIRING MUST CONFORM TO LOCAL
AND NATIONAL ELECTRICAL CODE REGULATIONS.
Please read the following instructions carefully before proceeding with the
installation. Failure to follow the instructions could damage the product or
cause a hazardous condition. Installation must be performed by a qualified
service technician or electrician. Disconnect power supply before installing in
order to prevent electrical shock.