Zapco C2K User Manual
Page 47
47
•
Slowly turn the ADJUST knob clockwise until you hear that the
speakers have reached their limit of travel, then, turn the control
back counter clockwise to a safe level.
•
If the speakers do not bottom out at max deck power, you can
bring up their level with the VOLUME setting of the amp. As soon
as any bottoming out is heard, stop increasing VOLUME and
switch over to Pre Clip to set the pre clip level.
5. Reset procedure:
•
With amp off, push in and hold the MODE SELECT button.
•
While holding the MODE SELECT in, turn on the amplifier.
•
This will reset all functions to factory levels. Volume…Minimum,
Pre Clip…Maximum, Turn-On…1 Sec.
6. Turn-on Delay: With the ON DELAY LED lit, turning the ADJUST knob
will vary the turn on delay from 1 to 4 seconds.