Specifications, Onkyo corporation – Onkyo TX-SV535 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Specifications
AMPLIFIER SECTION
Power Output:
I
Stero mode
ÍM Distortion;
Damping Factor:
Input sensiti\’ities and impedance
Front L/R channels
80 watts per channel min. RMS. at 8 ohms,
both channels dnven, from 20 Hz to 20,000
Hz, with no more than 0.08% total harmonic
distortion.
Continuous power output:
2 X 100 W'utts at 8 ohms (DIN)
I
Surround mode and Multi source mode |
Front L/R and center channels
65 W + 65 W + 65 W (I kHz 0.08 % 8 ohms)
Rear channels (Rear only driven)
25 W + 25 W (I kHz ' 0.8 '/f
8 ohms)
Remote channels
65 W + 65 W (1 kHz 0.08 N 8 ohms)
0.08% at rated pow-er (FRONT)
60 at 8 ohms (FRONT)
Output level and impedance:
Phono Overloiid:
Frequency Response:
RIAA Deviation;
Tone C^introl:
Signal to Noise Ratio:
Muting:
VIDEO SECTION
Signal sensitivity and
impedance:
TUNER SECTION
EM:
Tuning Range:
Usable Sensilivitv:
50dB Quieting Sensitivity:
C'apture Ratio;
image Rejection Ratio:
IF Rejection Ratio:
Ratio:
Phono;
CD/Tape play/Video in:
2.5 mV/50 kohms
150 mV/50 kohms
I a[)C rec/ viueo oiii:
i no m v/z.z Konms
Pre out (SUBWOOFER): 1 V/2.2 kohms
120 mV RMS. at 1.000 Hz. 0.5% THD.
20 to 30.000 Hz. +/-I dB
20 to 20.000 Hz. +/-0.8dB
BASS:
+/-10dBal 100
Hz
TREBLE;
+/-10dB at 10.000 Hz
PHONO:
80dB (IHF A. 5
mV input)
CD/TAPE:
lOOdB(IHEA)
- oo OB
VDP/VCR input, output: 1 Vp-p. 75 ohms
87.5--
Mono;
Stereo:
08.0 MHz (50 kHz steps)
11.2dBf, 1.0 pV (75 ohms)
0.9 pV (26 dB S/N. 40 kHz Div.
75 ohm DIN
17.2dBf. 2.0pV(75ohms)
23 pV (46 dB' S/N. 40 kHz Div.)
75 ohm DIN
17.2 dBf. 2.0 pV (75 ohms)
37.2 dBf. 20 pV (75 ohms)
Mono:
Stereo:
1.5 dB
USA &. Canadian models:
Other area models:
90 dB
Mono 73 dB
Stereo:
67 dB
40 dB
85 dB
Alternate Channel Attenuation:
\yi Suppression Ratio;
Total Harmonic Distortion;
Frequency Response:
Stereo Separation:
Muting Level:
AM:
Tunint! Rantie;
Usable Sensitivity:
Image Rejection Ratio;
IF Rejection Ratio:
Signal-to-Noise Ratio:
Total Harmonic Distortion:
GENERAL
Power Supply:
Dimensions (W x H x D):
Mass:
55 dB. 50 dB (DIN)
50 dB
Mono:
0.15%
Stereo: 0.25%
30
__ [533(30 Hz +/-1.5 dB
45 dB at I kHz/30 dB
at 100 — 10.000 Hz
17.2 dBf. 2.()pV (75 ohms)
European models
522 — 1611 kHz (9 kHz steps)
USA & Canadian models
530 — 1710 kHz (10 kHz steps)
Worldwide models
531- 1602 kHz (9 kHz steps)
530— 1710 kHz no kHz steps)
30 pV
40 dB
40 dB
40 dB
0.7%
USA & Canadian models
ACÌ20V. 60Hz
European models
AC230 V. 50 Hz
Worldwide models
120 and 220-230 V switchabic. 50/60 Hz
455
X
170x 389 mm
17-15/16"
X
6-1 1/16"
X
15-5/16"
ll.8kc(26.0 1bs)
Specifications and features are subject to change without notice.
This device employs a microcornpuler to perform various functions and operations. If interference generated by an e.xternai pow'er supply, radio waves, or other
electrical source results in an accident which causes the specified operations and functions to operate abnormally. To perform a reset, please follow the proce
dure below.
1. Press and hold down the VIDEO-1 button, then press the POWER button.
2. After "dear" is displayed, the preset memory and each mode stored in the memory, such as surround, are initialized and w'i
return to the f¿ictory settings.
SN 29342253Y
ONKYO CORPORATION
QMi^YO CORPORATION
Sales & Product Planning Div.: 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572, JAPAN
Tel: 0720-31-8111 Fax: 0720-33-5222
ONKYO U.S.A. CORPORATION
200 Williams Drive, Ramsey, N.J. 07446, U.S.A.
Tel: 201-825-7950 Fax: 201-825-8150
ONKYO EUROPE ELECTRONICS GmbH
Industriestrasse 18-20, 82110 Germering, GERMANY
Tel: 089 84 93 20 Fax: 089 84 93 226
ONKYO FRANCE
Immeuble Le Diamant, Domaine Technologique de Saclay, 4 Rue René Razel,
91892 SACLAY. FRANCE Tel: (1) 69 33 14 00 Fax: (1) 69 41 35 84
II
107960