SINGER 147-29 - Manual (Page 9)

18 Pi'
NO. PI.ATE
38482 8910
207n 8910
64355 8910
64356 8910
460c 8910
51330 9858
207n 8910
46009 9858
190 d 8908
54094 8922
54095 8922
68164
9858
14491)8922
54096 —
2 1 1 E 8958
46090 9852
742 f 8910
I'AirrS FOR MACHINE No. 147-29 19
“ Screw.
Thread Guard
(bra.ss)........................................................
Thread (under) Take-uj) Thread Guard
Steady I’in..................................................
d’iu'ead (uniler) Take-\ip 'J'liread Guard
Steaily Pin Set Screw.................................
Thread (upper) Controller..............................
“ “ “ Screw.......................
Eyelet.................................
“ “ “ Screw..........................
“ “ Take-up....................................
Plate...................
“ “ “ S p r i n g
ti U i i
Screw..........................................................
Tliiead (upper) 'I'ake-up l.•omplete, .No.s.
M49i). 51091, 54095 and 08101...............
'I'liread (u|)|)er) Take-u[) Set Screw..............
'I’liroat Plate, for in. to in. gauges,
for 40081....................................................
Genuine Singer Needles and their Con­
tainers are marked with the Company’s
Trade Mark “SIMANCO.” i
Needles in Containers marked
“For Singer Machines”
are not Singer made needles.
LIST OF PARTS COMPLETE
FOR
евазч
MACHINE No. 147-38
FOR WORK ON AWNINGS, HEAVY OVERALLS, STITCHING
FRINGE AND TAPE TO RUGS AND WORK OF A SIMILAR
NATURE REQUIRING A LONG NEEDLE BAR STROKE AND
PULLER FEED. TWO NEEDLES, TWO LOOPERS, FOR
TWO THREAD CHAIN STITCH. FOOT LIFTER. GAUGES
A TO 3/s INCH. NEEDLE BAR STROKE 1A INCH.
UPPER THREAD NIPPER. THE MACHINE IS FITTED WITH
UPPER AND UNDER CORRUGATED FEED ROLLS ATTACHED
TO THE MACHINE TO ASSIST IN CARRYING THE MATERIAL
FROM THE MACHINE AFTER BEING STITCHED. THE
UNDER ROLL RECEIVES ITS MOTION FROM AN ADJUST­
ABLE ECCENTRIC ON THE ROTARY SHAFT, BEING IN­
DEPENDENTLY ADJUSTABLE TO BRING THE MOTION OF
THE FEED ROLLS IN UNISON WITH THE FEEDING MECH­
ANISM. SPEED 2800.
N ote : Fittings as listed are for Lap Seam Felling on
Awnings or work of a similar nature.
NO. nl.ATE NAME
*1)8217 ------ Arm, upper and lower (solid) with 948n
and 54034....................................................
184ia—2