Oven vent, Notes, Oven racks – Maytag T1 User Manual

Page 13: Half rack, Rack positions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Oven Vent

When the own Is in use, the area near the vent may feel hot or
warm to the touch. Never block the vent opening.

OVEN VENT LOCATION

. on glass-ceramic range

coil element range

for roasting small cuts of meat, casseroles, baking

loaves of bread, bundt cakes or custard pies.

for ntasting large cuts of meat and poultry, frozen

pies, dessert souffles or angel food cake.

Multiple Rack Cooking:

,

a

Two rack: Use rack positions 2 and 4, or 1 and 4.

On a coil element surface, be sure the drip bowl

in the vent location has a hole in the center. Do

not cover the drip bowl with aluminum foil.

OVEN VENT

OPENING

Half Rack

(select models)

Support

Oven Racks

[^¿"

caution

: D

o

not attempt to change the rack posi­

tion when the oven is hot.

Your oven has two racks. They are designed with a lock-stop

edge.

Select models have one regular

a

rack and one RollerGlide'^^ rack.

The RollerGlide'^^ rack rolls out

on metal rollers and allows the

rack to fully extend making it

easy to place food in and lake

food out of the oven.

To remove flat rack: Pull rack straight out until it "^ops at the
took!" p position; lift up on the front of the rack and pull out.

To remove RollerGlide™ rack: Pull both the rack glide and

the rack base out together. (See graphic above).

To replace: Place rack on the rack support in the oven; tilt the

Lntendupslightlytsliderackbackuntihtclearsthelock

stop

position; lower front and slide back into the oven.

Rack Positions

RACKS (TheRollerGlide™

rack on select models is

not recommended on rack
position 5); Used for

toasting bread or broiling

thin non-fatty foods.

RACK 4:

Used for most broiling.

® u“ for most baked goods ou a cookie sheet or jehy mil

pan, layer cakes, fruit pies, or frozen convenience foods.

Tabs

To install in oven:

1. Always install half rack

when oven is cool.

2. To install, grasp top center of

the half rack. Align the side

back frame of the half rack into the slots on the upper left

rear of the oven wall.

3

Push firmly on the top surface of the half rack untiUhe tabs

slide into the slots and the half rack side arm support rests

on the fourth oven rack guide.

4. Check for proper installation by placing your hand on ____

top surface of the half rack

^

and pressing down firmly.

To remove from the oven:

When the oven is cool, grasp the

top center of the half rack and

pull upward until the back tabs

on the rack slide out of the oven

back slots.

Notes:

Do not use cookware that extends beyond edge of rack.

For best results, allow two inches between the pan placed

on the rack and the oven side wall.

When opening the oven door, allow steam and hot air to

escape before reaching into the oven to remove food.

Use caution when removing items from the half rack to

avoid bums.

. Carefully remove items from the lower rack to avoid

disturbing the half rack.

. “HALFRACK” Accessory Kit available from your dealer

when not included with range.

12

Advertising