Preliminary steps, Getting ready to sew – SINGER 413 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
GETTING READY TO SEW
preliminary steps
CONNECTING MACHINE
Before plugging in your machine, be sure
that the voltage and number of cycles
indicated on the plate under the hand
wheel conform to your electrical power
supply.
Push the machine plug into the receptacle
at the right end of the machine. Then
connect the power-line plug to your
electrical outlet.
Machine Plug
OPERATING MACHINE AND
CONTROLLER
To turn on both machine and sewing
light, turn power and light switch to the
right to ON position. To turn off machine
and light, turn switch to left to OFF
position.
Electrical Connections
CAUTION: We recommend that you
turn off the power and light switch before
changing needles, presser feet and throat
plates and when leaving the machine
unattended. This eliminates the possibility
of starting the machine by accidentally
pushing the speed controller.
To run the machine, press the speed
controller. The harder you press, the
faster the machine will sew.
To stop the machine from sewing,
remove pressure from speed controller.
Power and Light Switch
Speed Controller