Cleaning and oiling your machine, Chapter 10. caring for your machine – SINGER 5147 User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 10. Caring for Your Machine
—A
B------- -e
i(e)
^ A ^
4
4 4
Top Interior Area
Face Plate Area
2
Removing Bobbin Case Holder
C L E A N I N G A N D O I L I N G Y O U R
MACHINE
CAUTION: Before cleaning your machine, d/s-
connect power line plug from your socket outlet.
Periodically, depending on usage, clean and oil
your machine as follows, using one drop of oil
on areas indicated:
• Top Interior Areas
To clean and oil top of machine, remove top
cover. Using a large screwdriver, remove
screws
A
and
B .
Periodically, apply a drop of
oil only to areas indicated, after cleaning.
To replace top cover, align it over screwholes
A
and
B .
Using a large screwdriver, replace
screws
A
and
B .
• Face Plate A rea
To clean and oil the front interior of machine,
swing open face plate to left. With a soft cloth
or lint brush, clean and oil points indicated by
arrows. To close face plate, simply swing it
back to right and snap it closed.
• B obbin Case H older
To clean and oil bobbin case holder:
• Tilt machine back. Remove cover. If neces
sary.
• Turn hand wheel until needle is at highest
position.
• Open hook cover.
1.
Remove bobbin case and open latches
A
and
B ,
as shown. For more information on
removing and replacing bobbin case, refer to
pages 12 and 13.
2.
Remove part
C
and part
D
of Bobbin Case
Holder, as shown.
3. Clean and oil areas Indicated by arrows.
4.
To replace bobbin case holder, insert part
D
with spindle E up, as shown.
5.
Then fit part
C
Into placé with flat side up, as
removed.
6.
Close latches
A
and
B
over part
C .
• Close hook cover.
• Replace bottom cover, if necessary.
36