Warning, Stuffer assembly, Ring nut loosening wrench – Cabela's Heavy Duty Meat Grinder 33-0101-C User Manual

Page 9: Thermostat circuit breaker reset

Advertising

-9-

-12-

STUFFER ASSEMBLY

1. Remove the

Ring Nut, Grinding Plate, Knife

and

Auger from the Grinder Head before installing

the

Grinder Head to the Main Body.

2. Align the notches in the

Grinder Head with the

tabs on the

Main Body.

3. Press the

Grinder Head against the Motor and

rotate it counterclockwise until it locks into place

(Figure H).

Insert the

Auger

into the

Grinder Head,

Auger Driver end first

(Figure I).

Place the

Stuffing

Spacer into the Grinder

Head. Make sure the

notch of the

Stuffing

Spacer fits into the

positioning pin of the

Grinder Head.

Insert the

Stuffing

Funnel through the Ring

Nut and then onto the

Grinder Head.

Turn

the

Ring

Nut clockwise onto the

threaded end of the

Grinder Head until it

touches the

Stuffing

Funnel. DO NOT over-

tighten the Ring Nut.

Place the

Tray on

the upright part of the

Grinder Head.

NEVER

use the

Grinder without

the

Tray installed!

Figure H

WARNING!

Before cleaning, assembling or disassembling the Grinder,

make sure the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE!

ALWAYS unplug the Grinder when not in use.

NEVER operate Grinder without the Tray secured in place.

To avoid serious or fatal injury, NEVER reach into any Grinder inlet.

ALWAYS use the Stomper to push food into the Grinder Head.

Read & fully understand all instructions & warnings prior to use.

WARNING!

Front Ring

Nut

Stuffing

Funnel

Stuffing

Spacer

Auger

Assembly

Grinder

Head

Tray

Stomper

with Lid

Auger

Driver

Figure I

RING NUT LOOSENING WRENCH

If the

Ring Nut becomes hard to remove, you can use the Ring Nut Loosening

Wrench to loosen it.

DO NOT use the Ring Nut Loosening Wrench to tighten the Ring Nut. DO NOT

over-tighten the Ring Nut.

THERMOSTAT CIRCUIT BREAKER RESET

If the

Grinder suddenly stops during use, it either is overheating or has jammed. The

following instructions will help get your

Grinder up and running again.

1. Firmly press the

Power Switch Button so the Grinder is turned “off.”

2. Unplug the

Power Cord from the electrical outlet.

3. Disconnect the

Aluminum Tray from the Grinder Head.

4. Remove the

Grinder Head from the Main Body.

5. Disassemble the

Grinder Head to clear any obstruction

which may have jammed the

Grinder.

6. Carefully lay the

Grinder onto its side with the bottom

facing toward you.

7. Press the

Circuit Breaker Reset Button (Figure L)

located on the bottom of the

Grinder near the Power Cord

storage cavity.

8. Set the

Grinder upright on its Feet.

9. Re-connect the

Power Cord to the electrical outlet.

10. Press the

Power Switch Button to turn “on” the Grinder.

11. If the

Grinder still does not operate, it most likely stopped due to overheating. If

this is the case, press the

Power Switch Button to turn “off” the Grinder.

12. Let the

Grinder to cool about 20 minutes or until it will operate again when turned “on.”

Figure L

Circuit

Breaker

Reset Button

Advertising